Trying to get my XYZ probe to work. I have the xPro v4 controller, grbl 1.1 and i use OB Control as the software. I copied the macros from https://ooznest.co.uk/wp-content/uploads/2018/11/Touch-Probe-Commands-Guide.pdf but the XYZ macros only work for the first Z-probing command, when the router bit touches the plate, the macro stops. The console has this to say about the whole macro: [10:04:25] [ G38.2 Z-25 F100 ] [PRB:0.000,0.000,0.218:1] [10:04:25] [ G38.2 Z-25 F100 ] ok When I run the commands separately, they all work fine. Is there a setting I'm missing?