Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Openbuilds XYZ touch probe turns green.....

Discussion in 'Interfaces' started by LARRY RADCLIFFE, Jul 15, 2022.

  1. LARRY RADCLIFFE

    LARRY RADCLIFFE New
    Builder

    Joined:
    Oct 21, 2019
    Messages:
    23
    Likes Received:
    8
    Brand new was working fine now whenever I touch the magnet to ANY part of the machine it triggers the green LED under the probe , and I haven't even probed yet?

    It was working fine previously.
     
    #1 LARRY RADCLIFFE, Jul 15, 2022
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    14,865
    Likes Received:
    4,283
    Your machine frame is accidentally somehow attached the DC GND. Look for endstops installed without the rubber spacer, or a AC EARTH to DC GND short
     
    #2 Peter Van Der Walt, Jul 16, 2022
    sharmstr likes this.
  3. LARRY RADCLIFFE

    LARRY RADCLIFFE New
    Builder

    Joined:
    Oct 21, 2019
    Messages:
    23
    Likes Received:
    8

    You were correct sir that was the issue! Thank you as always!
     
    #3 LARRY RADCLIFFE, Jul 16, 2022
    Peter Van Der Walt likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice