Welcome to Our Community

Some features disabled for guests. Register Today.

Need help with xPro V4 communication problem

Discussion in 'General Talk' started by Richard3hybarger, Feb 12, 2019.

  1. Richard3hybarger

    Builder

    Joined:
    Oct 5, 2016
    Messages:
    5
    Likes Received:
    0
    I have just completed the Lead 1010 build with the xPro V4 controller and have installed the Open Builds Interface Driver program . However, when I activate the Driver program the software does not detect any Com Ports. When connecting or removing the USB interface cable, Windows make the familiar sound indicating that the connection has been established, so I know the cable is good. Any suggestions?
     
  2. Gary Caruso

    Gary Caruso OpenBuilds Volunteer
    Staff Member Moderator Builder

    Joined:
    May 19, 2016
    Messages:
    1,193
    Likes Received:
    532
  3. Richard3hybarger

    Builder

    Joined:
    Oct 5, 2016
    Messages:
    5
    Likes Received:
    0
    I couldn't find any drivers. I was thinking that would possibly be the issue, but wasn't able to find a driver. Can you assist? Thanks.
     
  4. Gary Caruso

    Gary Caruso OpenBuilds Volunteer
    Staff Member Moderator Builder

    Joined:
    May 19, 2016
    Messages:
    1,193
    Likes Received:
    532
    Click on the blue link above :)

    or here

    Or I believe the arduino IDE drivers work too and have some functionality for other arduino projects.
     
    Peter Van Der Walt likes this.
  5. Richard3hybarger

    Builder

    Joined:
    Oct 5, 2016
    Messages:
    5
    Likes Received:
    0
    Thanks -- I'll give it a go. Hopefully this will get me going again. Looking forward to making some dust.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice