Welcome to Our Community

Some features disabled for guests. Register Today.

Budget 1500mm OpenBuilds V-Slot Deltabot Build

Discussion in '3D printers' started by dodgenet, Jan 24, 2017.

  1. dodgenet

    dodgenet New
    Builder

    Joined:
    Feb 15, 2015
    Messages:
    2
    Likes Received:
    5
    dodgenet published a new build:

    Read more about this build...
     
    #1 dodgenet, Jan 24, 2017
    Last edited: Jan 24, 2017
    Fred Quarles and Mark Carew like this.
  2. Kyo

    Kyo Veteran
    Staff Member Builder Resident Builder

    Joined:
    Feb 27, 2014
    Messages:
    673
    Likes Received:
    702
    Looking good dogenet, Nice to see I am not the only one working on a really tall (1580mm ) delta :thumbsup:
    What length did you go with for your horizontals? My mock up unit is using 500mm but I have not finalized it as of yet.
     
    dodgenet and Mark Carew like this.
  3. dodgenet

    dodgenet New
    Builder

    Joined:
    Feb 15, 2015
    Messages:
    2
    Likes Received:
    5
    Hello Kyo, I had forgotten, but just measured them and got 750mm. I think somewhere around 500-600mm is more realistic, as I kind of regret the width.. I designed it so it would only fit through 36" doorways, haha. If I make another, it will fit through smaller doorways.. Good luck with the build! Sounds much more practical than the Part Daddy, not that I don't drool over that beast of a Delta...
     
    Kyo likes this.
  4. MaryD

    MaryD OpenBuilds Team

    Joined:
    Apr 13, 2016
    Messages:
    649
    Likes Received:
    639
    This looks cool!
     
    dodgenet likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice