Separate names with a comma.
Some features disabled for guests. Register Today.
in line 217 shouldn't the 'Z-5' be Z[-tc_seekdistance] ?
well, 'run job' is enabled, so, 'stop job' is disabled because a job is not running (-:
The CAM needs to know the cut speed (it does) and how fast your machine rapids (it doesn't) to get this accurate.
Assuming you are using OpenBuildsCONTROL and have homing enabled and are using it, then see my post for that-jim at INTERFACE controller go to...
the worn brushes makes more sparks on the commutator. more sparks means more electrical interference (EMI) is transmitted. and that is what caused...
This was bothering me too, especially in gcode generated by SketchUcam, so I modified it and the most recent release will always start the job...
this is not a problem for GRBL as it has been tested thoroughly on the Uno. The new Blackbox X32 uses the ESP32 processor which has a lot more...
you need to infect a township comittee members with the CNC bug, then you can do anything you like (-:
I see 2 minus signs -- instead of - which is exactly what the error message is pointing out, invalid format of the number
no G53 in that file, but it does have a T1M6 toolchange which you will need to remove. some resources for you to learn from: (knowledge is...
and you are sure the Gcode is not just cutting another layer deeper ? please upload the gcode so we can see it
so you have just rewired everything (-: so my vote is for a partial connection in that motors plug where it plugs into the X32. but do check the...
each stepper driver needs to have 2 pins connected, the step/pulse pin, and the direction pin if it only goes one direction, that may be because...
I would replace the USB cable with a quality item, 4 feet or less.
you do have to select the Uno under Boards and the correct port otherwise it won't work.
the code says var plasma_pierceHeight = 1; // set by onParameter from Linking|PierceClearance and on the Linking tab we see the Pierce Clearance...
either you mean it becomes impossible to turn by hand, which is correct when it gets power or you mean it is turning and then stops when it should...
try the instructions (-: OpenBuilds-Fusion360-Postprocessor/README-plasma.md at master · OpenBuilds/OpenBuilds-Fusion360-Postprocessor
acorn is an integrated software and hardware solution mach3/4 can drive existing drivers via one of the compatible usb interfaces. some of the...
reading what you wrote, the pins OUTPUT. (and the M7/M8 commands are for controlling coolant outputs, nothing to do with probes.) yet, the probe...