Separate names with a comma.
Some features disabled for guests. Register Today.
and, oops, you linked to the old wiki which may not have all the current settings. The whole project moved and got reorganized a bit, so here is...
OpenBuilds CONTROL dispalys them quite nicely but does not provide all the definitions, so you will need the wiki as you linked it. There are some...
non english characters in the filenames? or anywhere else they might make it into the gcode?
please post a picture of your controller and probe. at a guess I'd say black to ground and white to pin A5 BUT first check really carefully that...
Anyone of the LEAD machines will get you started. Get the kit, get it working, get some experience cutting christmas ornaments, then modify for...
set the spindle start time delay in the postprocessor options. If you hover your mouse over each option it will pop up some help, read them all,...
Yes, I believe so, since the clamp itself can flex (everything flexes, I can measure flex in my cast iron lathe with just fingertip pressure,...
if you want rigidity then I believe you need 2 clamps holding that router. I ran mine for a while with a single clamp (holding a Dremel) and could...
[MEDIA]
you want to be producing chips instead of dust. so 180ipm at 10000RPM for 0.01" per tooth on a 2 flute or 100IPM at 10000RPM on a single flute for...
do make sure your defined positions have Z as high as possible without triggering the limit switch. you do not want a rapid goto to dive Z down...
I would try the cheapest *thin* superglue from a dollar store, it will soak into the paper and set instantly, turning it into a paper/plastic...
Do not use R format, only I J K format for arcs. While R will work most of the time, there will be times when it does not work and will try to do...
I would not bother. I spent a week drilling and fitting blind nuts and never used them and have since replaced that spoil board. a) the masking...
you can change the default extension that Sketchucam uses: no surprise, it is in the user manual (-: SketchUcam: HOWTO set default options which...
don't forget to reset the blackbox after changing the steps/mm numbers. my process is to go back to 0, then hard reset, then run the calibration...
you can use GRBL settings calculator to get initial numbers for the belts, but then do at least 2 calibration cycles
SketchUcam does not output DXF files, it outputs Gcode. SketchUcam has never used the 'save as type' mechanism, you click the big green arrow in...
no math needed, just use the wizard in OBControl (-: but if you really need the math, go here
Update to the latest release, this should do what you need Release V1.0.31 · OpenBuilds/OpenBuilds-Fusion360-Postprocessor