Separate names with a comma.
Some features disabled for guests. Register Today.
a particular file or any file?
Hi how about putting the radio on a stool and attaching 24" dowels to the sticks. now, instead of using finger movements you can use arm...
The Blackbox runs GRBL firmware. GRBL supports the simplest subset of Gcodes, documented in the wiki (you should read that whole wiki, knowledge...
please read all of this docs:interface:start [OpenBuilds Documentation]
I would avoid the jog commands You need to set up a gcode file with a long string of repeated 'go right, go left, go right, go left' commands G21...
why are you sending 'connect' ? that does not exist anywhere in the GRBL wiki, and is not part of the Gcode standard either. "G0-F200-X10" will...
no such thing as 'over built' there is only 'built correctly' and 'not built strong enough' (-:
You need to calibrate to make sure that it is still moving accurately after a year or two of belt stretch. Then you need to fine tune your max...
The drawings know the size (-: at OpenBuilds OX CNC Machine under 'files and drawings'
When you look at the steppers make sure they are able to be wired as '4 wire bipolar'. Some rare steppers have only 3 coils, and some have 5, and...
Yes, the Gcode is doing a retract before each layer. Search the Vectric settings for a way to prevent that. sometimes called 'stay down',...
How about heat buildup in the Blackbox? Everything properly cooled? How about adding a desk fan pointing at the BB+PC from 4 feet away....
yes, maybe, probable (-: 'as much as possible' rather than 'a bit' wire spacing is subject to inverse square laws, double the distance gives...
I would use a macro button in Openbuilds control to move the machine to the sharpie offsets (in G54), select G55, then use the 'setzero' buttons...
You have bundled the limit switch wires with the stepper motor wires. That is mixing low voltage (sense) wires with high current power wires, a...
still this....... X did not decelerate at the switch, THAT is a problem that must be addressed.
number of work offsets must be 6 ultimately is does not matter, that is just a warning that you have not set a post for your 'machine config'....
make sure you unplug the USB cable from the BB so the Mega can use the serial pins unhindered. this delay (and the others) will give you...
You will have to point out this 'new warning' as I don't think I see anything new. if you mean the yellow bit of text in the simulation edit box...
I liked your post = yes (-: then forgot to put it in words....