Separate names with a comma.
Some features disabled for guests. Register Today.
G21 yes, G91 no The way G91 is used in the macro in lines like G91 G0 Z3 makes it only apply to that line, and that is correct within the macro....
Hiya Since G20/21 is modal, ie it gets remembered, the right thing to do is always set it to what you want. This means always setting it in the...
ah, ok, in platform it is accessed via tools options UGS Controller options
SketchUcam generates the Gcode. Then you feed the Gcode to whatever controller you prefer. I don't think that is the implication, only that it...
must say my OX accelerates a LOT faster than that (-: in fact I had to turn it down a bit because it shook the table.
UGS will have popped up a prompt saying something like "this code is not supported do you want to skip it?" and you answered YES. What UGS did...
technically 2 bits of software, the cam which is a web application and the control driver which runs on the computer. they work together to run...
love this 'standard measurements' thing. only standard in America, known as 'Imperial' everywhere else, and is not the standard. (-: the meter...
lol, the obvious.... OpenBuilds CAM Gcode Creator - Public Beta For more complicated stuff. Sketchup Make 2016 + the SketchUcam plugin....
GRBL does not support tool change codes, so just remove the T0 M6 line. It also does not support the G64 command, so remove that too. all those...
Hi Assuming you have it wired for PWM power setting you can turn it on 'very dim' and set the focus (wearing your protective glasses of course,...
lol, yeah, just leave it alone to run the gcode (-: (and turn off all power saving, screen saver, auto updates etc) although there is a buffer...
Well, GRBL just does what the Gcode tells it to do.... Here is some example code that will use a 6mm bit to make a 10mm wide hole, 10.5mm deep,...
Hiya ho hum, my post has failed for your case of using a 1mm bit for those tiny slots. If you send me your fusion file I will try to solve it but...
I have just run that file through bCNC to an UNO with GRBL 1.1 without any issues at all. Note this was not check mode, but actual cut mode,...
try Candle, it jogs 'correctly' (-: Denvi/Candle
minimum stickout.... but, do not put the flutes into the collet, nor any tapered part.
the RAMPS board is terrible (in terms of pin layout, very different to the optimized GRBL layout) and is not fully supported as an official GRBL...
then you are asking in the wrong place (-: This points to a bug in the mega/ramps software so you need to create an issue report on github where...
what you want is LinuxCNC which can do custom motion kinematics across 9 axes. LinuxCNC LinuxCNC Documentation Wiki: Kinematics [MEDIA]