Separate names with a comma.
Some features disabled for guests. Register Today.
There are many methods but maybe the easiest is the 'paper feeler' method. like this: [MEDIA] If you want super accuracy then you need to set up...
Can be done, but it might be a lot easier in terms of software toolchain to just use an OX or C-beam and do the last in 2 halves,... left side,...
I just found this today... Power Cabristor: DRV8825 missing microsteps looks like the 8825 struggles at low speeds, but adding some diodes fixes it.
well, that lists G21 as active. you can also give the command G21, just as you did for $G and that would set G21 active. So if that was already...
If output is too large then those values need to change UNLESS you are not including a G21 in your Gcode. G20 sets imperialmode G21 sets metric...
Good post Strooom. That last thing, and in fact any unknown system can be solved like this: set steps/mm to 1 (yes, ONE) command a move, might...
seems to me Marlin needs fixing... and someone needs to RTFM because SketchUCam has a Marlin output mode, and can also turn comments off or...
You have the terminology wrong I think..... The motor is 200 steps per revolution. The driver can multiply that by 1, 2, 4, 8 or 16. This is...
Microstepping explained: Microstepping, Full Step & Half Step The chip on your stepper driver can do different levels of microstepping, from full...
"if you only have one copy of a file, you only THINK you have the file" backup your backups....
Seems to me that you have not set your microstepping and it is full stepping. Set microstepping to 8x using the jumpers, then do this calibration:...
Looks like your motors are missing steps. This means they need more power, or less speed. Often the problem is an acceleration setting that the...
Theoretically we can calculate the needed thread or belt reduction. However, we must remember that microstepping is not accurate so we are going...
I suggest splitting them into chapters about 15 to 20 minutes long. Once they are on youtube you can set up a playlist to play them all in order,...
No, I will not put it on any other server. Did you register? Did you login? If you did then maybe try a different browser, I have seen such errors...
Postprcessor for Aspire and VcarvePro The Shapeoko Forum • View topic - Using Vectric Aspire to generate Shapeoko g-code From the above, it looks...
Julio, please do not post the same thing many times in reply to many posts. The link is working just fine, but you do have to register and login...
Told y'all so.....
The helical arcs will work fine, just like make sure you use either quarter arcs if using R format, or use IJK fromat if you want to use full...
yes, the endmill will affect the amount of power required to push it through the work. If it is blunt it is harder to move it forward into the...