Separate names with a comma.
Some features disabled for guests. Register Today.
What controller are you using? It is the controller that controls the power to the motors so that is where we need to change a setting.
Have no clue about that (-: My father told me about the kero and I discovered the wax on my own. Dad also told me about chicken fat on steels, it...
I don't think there is such a file unless there is someone with an identical machine. I am sure the Cnc USB manual will tell you how to set it...
basics that ISR speed setting is for engraving with lasers. if you ware never using laser, you don't need it. details: engraving with a laser...
One can also use wing shields to connect the wires to the Arduino Screw Shield - Shield for Arduino - Seeed Studio [IMG]
pointing with leadscrew ===> BOSS LEVEL (-; PS thanks for using a tripod for the camera
I don't know vcarve at all, but here are 2 other solutions... (1) In Sketchup just draw a rectangle the size of your spoil board, left bottom...
The first thing is this (Generated by SketchUcam V1.3a) please get the latest version and install it! SketchUcam Then I see in the Gcode...
I don't get this high cost (-: At least for Fusion360 the post processors are written in Java and are user modifiable. There is at least one...
Do you have a safety door switch connected to the 'feed hold' pin? If you do then that wiring needs to be shielded or otherwise guarded against...
no, in both M3 and M4 it will only turn on when there is motion, when $32=1 this is the whole point of the laser mode in that the laser is only on...
you make it MOVE (pretty sure I did point this out?) issue the manual commands: M3 S1 F10 ; set parameters G0 X10 ; go...
SketchUcam can generate this code with one extra mouse click (-: 'Laser mode' checkbox on the parameters dialog. The $32 mode does not actually...
from the wiki... The laser will only turn on when Grbl is in a G1, G2, or G3 motion mode. In other words, a G0 rapid motion mode or G38.x probe...
you need to read the manual! -> Grbl v1.1 Laser Mode · gnea/grbl Wiki · GitHub summary: with $32=1 the PWM output only comes on when there is...
The correct solution it to edit your post processor, correct Gcode, as I know it, is: G0 X1 Y6 Y7 hmmm, reading some docs like G-Code Tutorial:...
and is it updated? the original USB code has bugs that cause streaming to stop.
If you look at the code in a simulator, is it complete? also check that your Arduino is not a clone with a CH430 chip, they tend to lose the plot...
Hi Get GRBL 1.1 here GitHub - gnea/grbl: An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized...
Hi According to this web site UGS it will run on the Raspberry you just need to make sure Java is installed and then unzip UGS where you want it.