Separate names with a comma.
Some features disabled for guests. Register Today.
I just tried this one Single Line/Stroke Fonts (for cnc engraving)?? • sketchUcation • 1 and will try these sometime... CamBam Stick Fonts Things...
Hiya If you have not yet, please watch this [MEDIA] Now, for such small text I would use an engraving bit, maybe 15 or 30 dregree point (I think...
assuming 3+2 operation: I would just set G54 for the top, G55 for left side, G56 for right, etc. Then Fusion just needs to be told which system...
oh, you didn't notice (-: (and not a grblpanelthing but a GRBLthing) I noticed that if I moved say X to 400 and then changed the steps/mm, when...
the GRBL processor does not have enough memory for this. the minimum you will need is a Raspberry Pi that can send the Gcode to GRBL. automatiing...
just disconnect the GUI and reconnect should do it, that normally makes Arduino based devices reboot. otherwise power cycle
you have probably been caught out like I was.... when you are calibrating you MUST move back to 0,0 before changing the steps/mm settings, then...
the direction pin will be 0v for one direction and 5v for the other direction (or values very close to those). the entire Arduino is 5v TTL...
so if it only goes one direction then the obvious thing to look at is the direction pin connection to the driver.
bCNC will also use an external number key pad for jogging, and setting the jog distance. let me clarify something. the XPro runs GRBL and does...
The GRBL wiki has a lot of info... gnea/grbl
first, slow down your max rates and acceleration in GRBL. However if this was too fast you would hear a whining sound, but you don't mention...
it probabyl has a sticky spot. make sure all the wheels etc are clean. then, in your controller, halve the max speed and acceleration settings for...
right here on this forum is a resource for calibration HOWTO Calibrate your CNC Machine for MACH3 or GRBL
Hi. are you cutting inside or outside your 50mm circle? Have you calibrated your machine HOWTO Calibrate your CNC Machine for MACH3 or GRBL BTW...
you need to use the spindle PWM pin and laser mode to achieve what you want. this is because in laser mode GRBL avoids stopping motion when the...
always vent outside. always. melted and burning plastics create very nasty byproducts. a motto : "if you can smell it, it is killing you"
it affect how fast and accurately the slopes are cut. (-: I suggest you get some insulation foam and experiement. the foam can be cut very fast...
@nportelli @crispin I have been using this dmap2gcode to create lithophanes but I am sure it will do reliefs, just fiddle with the settings till...
maybe you shoudl ask the 5x developer what he uses? in other words, open an issue on github fra589/grbl-Mega-5X I just read quite a bit of the...