Separate names with a comma.
Some features disabled for guests. Register Today.
already answered in the Sketchup thread.
Hi The way Sketchup cuts off the ends of arcs can be a problem for Gcode generation because the centers get lost. The way to fix it: remove the...
sure can. MCS= Machine Coordinate System, ie the system where home is defined (1). WCS = Work Coordinate System, one of G54 to G59, what you set...
Hi We are going to need more information on this. Do you mean GRBL reports an arc error 33 or do you mean the arcs are not cutting or do you...
I have no enable lines hooked and it all works perfectly.... I do have a power switch on the stepper PSU that I use as a 'emergency stop'. I plan...
Peter bCNC has internal variables that are available for use within manual/macro code. This allows you to do stuff like G0 X[maxx] which will move...
I don't think you need hard limits set. you will need to set the homing directions correctly, normal homing is at max travel ends (industry...
the trick with printing to scale is to turn off the perspective view Camera menu, untick 'perspective'
have you tried the maksing tape and superglue method? I am using it for just about everything. [MEDIA] also, I spaced my grid at 100mm which is...
and what would be really nice is continuous jog the way candle does it. hold down the button and it moves at a selectable rate. release the button...
you must put the grub screw up against the flat spot in the motor shaft. if it does not have a flat spot, make one with a Dremel.
Peter, what if the last job run issued a G20? Then the G0 Z5 will try to move 5 inches, ensuring a crash on most routers!
alarm numbers are here 8 Grbl '$' command cannot be used unless Grbl is IDLE. Ensures smooth operation during a job. 9 G-code locked out during...
I believe the right thing to do is to teach users as early as possible that turning on with Z high is the right thing to do, always. This makes a...
no limit switches meand you do not need homing cycle active, so please set $22 to 0 then it will not turn on in an alarm state. I would : set...
are you using ramped entries into the cuts? maybe try a continuous spiral cut instead? (I cannot recall exactly how to do it, NYCCNC did show it...
that should really be a G53 move that lifts Z as high as possible before moving. this will then clear (at least more likely!) any clamps and...
or your Z acceleration is too fast and it is missing steps when it retracts. reduce the acceleration on Z by 25% and see what happens.
in bCNC you can turn off sections in the editor, this makes it easy to turn of everything (except the header and initial safety moves) up to the...
the reason those lifts are expensive is because of the safety that is built in. the chair has to be able to take a large person flopping down onto...