Separate names with a comma.
Some features disabled for guests. Register Today.
No they are a Toshiba chip as mentioned elsewhere. I would use DQ542 drivers, very happy with mine. DQ542MA Stepper Motor Driver
While I am here can someone explain the 'emporer' in Braille on the Blackbox?
I think I have the answer to this ... on the board is the header where you select which of X Y or Z gets duplicated onto the extra driver. so we...
sure? my memory says 30khz, so does grblcalc
possible but not recommended. good chance one of them will be starved of resources and ruin either the 3D print or the router job. A Raspberry...
I need to cut a tool board soon and will try this outside cut first thing on some scrap before I do the master cut. Intrigued
btw, why does Grimsmo NOT have an Ox for cutting those foam inserts? seems the obvious solution to me, keeps the big mill clean and free to make...
I have had success doing this with various foams. Kaizen not available here but I have tried various polystyrenes and those rubber matts that...
These are 'consumer' leadscrews, made by rolling usually. [MEDIA] With this process there is always some slippage which means the pitch is not...
what you want is bCNC, it can not only probe the surface, but also save the mesh and/or use it to make 'flat' Gcode fit the surface; vlachoudis/bCNC
agree, a macro should leave the machine in a consistent state, something you can count on. One thing you can count on is that you don't know the...
that RGB LED.... I wonder if I can shoehorn an ATmega328 in there somewhere that drives it with different colours? Maybe sense motor on and...
if you have enough axis in the controller then I think you can certainly drive the rollers through Gcode but you would have to add that to your...
my Ox is in the 'craft room' which used to be the lounge. At my wife's suggestion. The vacuum cleaner is much noisier than the Makita router and...
it depends where you have put the co-ordinate origin in fusion. I suggest putting it at 'stock top' (front left corner is what I like) and set the...
The easiest way by far is the Openbuilds CAM system. Followed by Sketchup Make 2016 + SketchUcam plugin. There is seldom need to write Gcode by...
Here is a 'more correct' version of your code, with comments to explain G20 G90 G17 ; set the modes you want, everytime, you cannot trust the...
not trimming, tramming the process of aligning the Z axis perpendicular to both the X and Y axes. [MEDIA]
Joe, Sphinx vs LEAD Z axis styles.
the 'single line' fonts I know of are TTF's with closed vectors that are just very close together or on top of one another. when I use them in...