Separate names with a comma.
Some features disabled for guests. Register Today.
aye, dialogs.... the more you add the more you have to make FAQ's and manuals and howto videos....
I use the masking tape and superglue method. The tape I am using is made by Wurth. (we dont get fancy colors or types of tape here in Africa, so...
Just installed .162 Works just fine for me under Xubuntu 18 though the old one (think it was 142) did not prompt for an upgrade. This is normal...
yeah, forget the negative numbers. jog to where you need the work o,o,o origin to be, hit the 'set zero' buttons and cut your job. assuming your...
I do use those sanding drums but most often just a square of 80 or 120 grit sandpaper glued to a piece of insulation foam. This will very...
Use the GRBL post. because GRBL only supports the bare minimum of codes and will throw errors on things like toolchange and tool offsets. a...
We need more information please. What are you using to generate the Gcode? Can you attach the Gcode file? and maybe the CAD file too? What...
In brief: G28 and G30 default to 0,0,0, ie at the home position, which is wherever you turned GRBL on if you don't have home switches. They are...
I find that GRBL remembers the previous WCS settings just fine through a power out. I do not have home switches so I just make sure the gantry is...
I have found that when calibrating it is best to move back to 0 before entering the new calibration value. This is when doing it manually in bCNC,...
Been trying to get it but the link to the linux .deb gives me [ATTACH] and there is no .deb on github
cool malapropism :)
bCNC can probe and adjust for alignment... have not tried it myself yet, I just use a square off the edge of the spoil board.
aye you did, obviously i should wake up before typing :ROFL:
if your max feedrate is 2000mm/min and your F word is F1000 then 200% of that is 2000mm/min. no problem there. similarly if F is less than...
0: probably, pretty much everything has been done, even if you can cannot find it on google (-: 1: yes. 2: no. because you need coordination...
The openbuilds cam app imports DXF , SVG, image, gerber and excellon files. So would need to get Sketchup to output one of those formats, DXF is...
I much prefer to use G53 moves instead of G28 or G30 G53 G0 Z0 G53 G0 X0 Y0 is a much safer sequence of raise Z to highest (same as home) and then...
I vote for tape and superglue I laid out my table with holes and blind nuts and have used them very little. Could have just put in 6 or 8 instead...
I am wondering..... my vague memory tells me that I saw 'somewhere' a note to always have motors connected when adjusting current. Is this a...