Separate names with a comma.
Some features disabled for guests. Register Today.
Here a half fuselage mould is being cut, but the idea is exactly the same as cutting a foam fuselage half. [MEDIA]
Yes I believe so. It all depends how you split the fuselage in the CAM software. you can do halves, top half/bottom half that are joined later....
for most shapes you do not need 5 axis as 3 axis can cut it using a ball end mill. I suggest getting a Workbee or Sphinx kit and using it for a...
As Peter said in reply to your other similar question, you need to read the wiki on interfacing with GRBL. After that you can start with one of...
Here are several options: you could find a programmer on a platform like Upwork.com that will write a program for you. the program would read...
As Phil As Phil said, if the bit size is the same size as the hole (in other words you are not setting a 'large hole' size) then a drill bit...
ok, what we first need to do is make sure the machine goes in the correct directions after that we can make homing work in the correct directions....
Did you load the default settings from OpenBuildsCONTROL? select 'GRBL settings' select your machine from the list next to the [1] select 'save to...
there is no need, though it can be done. GRBL remembers the offsets for you, yes even when power is off. all you need to do is send it back to...
Peter, of particular interest is number to string formatting for Gcode output. I have included a check for locale specific number formatting in...
looking good! bits are seldom the size stated on the box, measure them then tell Fusion the exact size. also, when calibrating you must calibrate...
seems to me you are getting a bit confused AND you have your home switches at bottom left which requires special GRBL setup. Gcode defines 7...
that is exactly the issue, your spindle (clip on the bit) is now controller GND so clipping the sense wire to it will always close the loop. by...
good question. I don't think it will need to be very far since the magnetic field falls off with the (roughly) inverse square of the distance,...
did you try the other clip on the bit? in other words, swap the clip wire for the plate wire.
This may be a better explanation: [MEDIA]
I am pretty sure this covers it.... Not sure where to put work piece but let me make sure of a few things.... So, to confirm, you have home...
reroute NOW, it will happen again. the simple rule is that power (wires to the steppers) and signals (wires to the limit switches) must not...
please post your gcode file (here or direct to me) and I will ruin it through my testbed and see if there is any problem with the gcode.
I use both bCNC and OpenbuildsCONTROL on my Xubuntu notebook. I transfer gcode files to it via Wifi. no problem.