Separate names with a comma.
Some features disabled for guests. Register Today.
right click the setup select 'edit' select 'post process' set the WCS to 1 (this tells it to use WCS G54, the default system) save post the...
correct. 1 blackbox or 3 drivers and do some manual wiring.
This is incorrect. X+ is tool moving right so that would be the MAX endstop (and the correct home) Z limit is ALWAYS at the top, which is Z+....
sort of. it will work but not at full power. the hat stepper drivers cannot supply enough power to the motors, they need 2 to 3 amps to work...
Sketchup 2016 + SketchUcam will do it. you may also need a DXF import plugin then, select the Centerline tool, set depth to 100%, select all the...
funny thing is after creating an optical tool height gauge last week I found that CONTROL does a fine job of probing Z height but bCNC does a poor...
also, if you cut a 2" wide hole and a piece of wood 2" long, the piece will not fit in the hole (with a hammer yes, but not just 'fit in'). it...
the meanings of those alarm codes are 8 Homing fail. Cycle failed to clear limit switch when pulling off. Try increasing pull-off setting or check...
This issue has been teasing my mind for a bit. I really don't want to connect a microcontroller pin to the spindle nor to a random bit of metal...
Gcode is just text, just like any other programming language. The extension on the file simply does not change what is inside the file so you can...
Just contact him (-: He is using LinuxCNC for the control, GRBL based controllers cannot do the rotary axis so you are going to have to use...
probably a good starting point. plasma usually needs more setup codes for torch height control and so on. the post is easy to modify to do...
like this? [MEDIA]
I have used dmap2gcode on my GRBL based machine, i cannot recall any issues with the gcode (the blackbox is GRBL based)
He must mean follow the instructions in the resource (-:
run the long axis on Y, the one with 2 rails, keep X short, the one with a single rail. in fact it is possible to 'rotate the machine' 90 degrees...
stepper motors cause vibration vibration causes nuts to come loose ===> check EVERYTHING. on my Ox all the motor bolts worked loose, every one of...
I spent hours creating a grid of holes with Tnuts, and almost never use them, mostly I use masking tape and CA glue. [MEDIA]
It is really a grinding operation I think. My instinct is to soft mount the router, some sort of resilient rubber mounting I think. Not too...
Then you need to look in the mach3 settings for the max rapid travel rates. If you don’t know where to look then check the manual, the mach3...