Separate names with a comma.
Some features disabled for guests. Register Today.
first you need to always turn on the controller, or reset it (which happens when the PC connects), with the Z as high as it will go. this I call...
I would not try to force Gcode to do this (and certainly GRBL cannot as it has a relatively high minimum feed speed). Instead I would use an...
check for dirt on the Y axis rails and on the wheels.
you need to use compatible dialogs SketchUcam: HOWTO set default options OR you need to install IE extensions for WINE, part of the winetricks...
200*8 = 1600 steps per revolution 8mm per revolution ergo 1600 steps/8mm = 200 steps per mm and then you do a fine calibration because the...
bCNC can do it I think, you do at least have access to the probed values
Set radial stock to leave to 0. This setting effectively makes the bit seem bigger and fusion thinks it won’t fit.
I don't see any dir/relay jumpers in the circuit diagram, you must have a new version. @Peter please put up the new versions and make it clear...
You are seeing that error because GRBL (what runs on the BlackBox) does not support toolchanges, the code is saying T1 ; be ready to switch to...
I had similar experience with bCNC with unending jogs that turned out to be the wireless mouse (I could actually see the button on the screen stay...
you need to change your post settings. please read this
No matter which post you use, you still need to understand the settings (read the popups as you hover over each setting) and set the heights in...
Use these settings for the fusion GRBL post. f360/ob control Or use the OB post Fusion 360: grbl post processor install (the easy way)
check for sticky spots in the travel. remove the leadscrew and move the carriage by hand, fix any sticky spots. while you have it out, check the...
if you only have 0.25 fo Z movement above the work then you have to be very careful in the toolpaths to specify a safeheight (where non cutting...
2.6 million lines in that file, not what one would expect from roughing (-: are you using fusion ? or at least something with an option to apply...
you title says soft limit, your text says hits limit switch. which is it? what is generating your Gcode? are the clearance heights correct?...
You need to change the microstepping setting on the Z axis driver, it appears to be x8 which is giving this high value which is also EXCEEDING the...
if it works there is no problem (-: in the bCNC folder is a bCNC.sh shell script, you should run it using that rather than using python directly....
Yes, it always outputs M3/M5 commands for spindle control. If you tick 'flood' for the tool coolant, and turn on 'has coolant' it will also output...