Separate names with a comma.
Some features disabled for guests. Register Today.
you mean Y is the roller, Z is the router movement, X is the carriage side to side
just set flatcam to mm? the machine controller internals are all mm, though it can ingest inches and cut just fine, the native units are mm so...
You don't have to do that, the offsets are stored in EEPROM when you set them, and will survive a power cycle. I have often stopped a job between...
I, well, beg to differ.... swarfer/sketchucam https://www.youtube.com/playlist?list=PLm728rLHCWOw-vRvTJwS_5MmKG1fs4sZ0
you have the fix (-: , there is an option in the fusion post for linearizing small arcs.... turn it on and regenerate your gcode. The issue is...
if you do not have home switches, then you need to fake the home.
also check Fusions heights tab for that operation.
those LED lights can also be noisy. my LED kitchen lights interfere with my TV in the next room, have to adjust the bunny ears for best picture...
that is EMI and just adding ferrites is not enough. you also need - star grounding - space between power cables and signal cables. You cannot...
check your Z axis, if it is moving a bit sideways you will see it on the X if the X skipped steps then it would not return to the correct path,...
Grew up and live in Grahamstown. Lived in PE for a few years though.
for 1. I'd say there is something stuck in one of the wheels that it is jumping over. does changing the job speed make any difference? does...
The problem is in CAMOTICS as it does not correctly interpret nor display G53 moves. I maintain and USE the OB fusion post, and I would have...
no, not at all.
does the same job run slow everytime? if so, you should turn on smoothing in fusion so it generates fewer lines of Gcode [MEDIA]
Yes of course, read about it in the manual or big blue question mark in the toolbar if you have no internet (-:
had that since day 3 after the big Fusion change. (-: it uses a state change loop to detect MMMM and then MMMM with the MMMMM until MMMMMM....
Use the OB post for GRBL. MAch3 should be happy with it, and it reinstates most of the rapids...
Rather use the correct post processor so it is always correct and you don't have to remember to fix it for every project
This Gcode cuts 6mm deep around the outside of the sign, you can see a Z-6 in the last block, so no problem there. This should help you...