Separate names with a comma.
Some features disabled for guests. Register Today.
it is not the Gcode, that only contains 2 speed instructions, both for 24000rpm. BTW: You did not use the OB post for Fusion, it is much better...
CTRL+SHIFT + will expand the display. the '=' is unshifted, the '+' is shifted
um, no..... a G0 move should move at 10000mm/min according to your $110-$112 settings. a G1 move will move at whatever is set by the F word, G0...
a new bit should do fine, I would use a single flute 3mm.
if you feel the cutting edge with a finger (power off naturally) and you are not scared of it, it is beyond time for a new bit (-:
if you have to use the handwheels, then SLOWLY. the faster the motors spin, the more voltage they produce, and that is what kills drivers.
sounds like they have laser mode set (GRBL $32 parameter)
OBControl does indeed do a G0 Z5 during a 'gotozero' sequence. Drives me crazy.... it should be a much safer G21 G90 G53 G0 Z-5 G0 X0 Y0 G0 Z5 ;...
both switches must be wired to the 'NO' Normally Open contacts. use the OBControl diagnostics to check switch status, each switch by itself, and...
why? The compute stick/hub can power the nano via usb, no problem, no need for an extra supply. the nano uses maybe 100mA. plenty for powering...
I just got the error 25 too on my test Uno. gcode attached
my Z probe uses a break beam from a laser printer. but instead of relying on the tool to break the beam (a 30deg Vbit will miss it more often...
I have just run gcode I created in Qcad using the GRBL inch and GRBL mm posts through OpenBuilds CONTROL without errors. What GUI are you using?...
Axis directions must be like this [IMG] ie, the relevant axis moves in the + direction when you jog + actual X0 Y0 may vary depending on how you...
use the 'spindle on/off delay', the popup help says "Time (in seconds) the spindle needs to get up to speed or stop, also used for plasma pierce...
does this work? you should see animated blobs WebGL Blobs
rotating a stepper motor makes it generate voltage, so moving the gantry generated enough volts to make the fan turn. if you MUST move the gantry...
I do, for one, so I can see what the post is displaying, and I prefer it to the NCprograms anyway since I tend to be testing single operations and...
add a resistor to up the current draw?
Yes, I am busy processing your pull request. Problem is the difference between the old post options display and the newer NCprograms style...