Separate names with a comma.
Some features disabled for guests. Register Today.
there were installation instructions on the wiki but I see they are missing. I have opened a bug report. meanwhile, follow GitHub - Harvie/bCNC:...
if you watch the video in the link i gave you can see that it is purely a setup operation..... 1 - bcnc probes the object surface and stores the...
I think a better way is probing so you can set the WCS correctly from what you have and then run the Gcode relative to that WCS (or even more than...
You can use bCNC to probe the surface and then use the probed mesh to correct for the curvature. Your Gcode is generated as for a flat surface,...
what bits are you probing with? some coatings on bits are not conductive....
There is no size limit, but there is a TIME limit, little edit box at top right of the 3D display. Code will run fine without being displayed...
hehe, Gcode is just "LOGO with consequences".
just tried various settings. if you have homing enabled soft limits disabled then you can jog (or command) moves to anywhere, including...
no, you cannot change the MCS, it is set by poweron/reset/$H command, that is all. everything else is an offset and does not affect the MCS 0,0,0...
install the drivers turn off power saving
once you have used 'setzero' the blackbox remembers the offsets, even through power down. Therefore you do not need to set the offsets after every...
I would - lower the homing speed - create a parking macro that sends it to 1/4" short of the home switches and use it EVERYTIME before power off....
bCNC already supports othographic, and will work with a Blackbox perfectly. also open source and multiplatform
first disconnect the PSU ground from the arduino and from the step/dir - pins. (power ground is not signal ground!) connect the pulse/dir - pins...
$H all the commands it supports are at Grbl v1.1 Commands · gnea/grbl Wiki but CONTROL takes care of the details most of the time, as would any GUI.
sounds like backlash to me, nothing wrong with the Gcode so if the machine is not moving smoothly is is probably a mechanical problem.
oh, just noticed you mention G28 for homing. What controller are you using? Standard GRBL in the Blackbox does not use G28 for homing, G28 is...
reading this G Codes tells us that G92.1 will remove the G92 offsets, leaving you with just plain WCS positions, and of course, MCS, Machine...
and if you are working in a vice it is common to set Y zero on the front of the fixed jaw, which is usually the back of the material.
i can imagine (-: no, please buy a kit from the store, then follow the instructions. As your first build you will be learning a lot, save the...