Separate names with a comma.
Some features disabled for guests. Register Today.
look at your $31 and $30 settings. are they 0 and 'max spindle speed'? The GRBL default is 0 and 1000 and since most spindles are higher than...
ah, then you need to fake the home How to 'Fake the home' having a good home position is not optional, safety moves rely on it.
and Home, Fusion360 and G53 Z moves
I think we need a 'have you updated you X32?" banner on the landing page (-:
that is my first thought too my second thought is that the switch is there to be triggered but must not act as a physical stop, the frame of the...
yep, all gcode must have a header that sets the modals to the values it needs. the moment you assume a mode is already set is the moment you are...
you need to calibrate X (well, and Y and Z, but mainly X). leadscrews are never absolutely accurate so there is a calibration wizard in CONTROL...
at first glance $30=24000.000 ; Maximum spindle speed, RPM means that your Gcode must send M3 S24000 in order to get 10v output
you need to make a backup of the settings from the old controller and then input them into the new controller. unplug the new one from usb plug...
in the GRBL settings page, reduce the acceleration rates to half what they are now and run a job. if it all works fine for this and a few more...
do a backup of the settings and attach that backup here
thanks! I understand better now. so, going back to your image.... with some notes [ATTACH] at (1) is the command sent by clicking the 'goto 0'...
the current state is G91 relative motion (you can see it in the $G status line). The jog command does tell it to use G90 absolute motion but it...
changing the motors to enabled will not affect how switches are sensed, at all. if the motors do not move then homing will never work so lets try...
$4=0 ; Invert step enable pin, boolean you need to invert that
seems it was already at 0 (shown in your pciture), therefore no movement
sorry, in the depths of the Eastern Cape. shoudl be plnty of videos on youtube....
a further small refinement is to deselect the 'order by depth' so that it finishes each pocket completely before moving to the next one.
you need to select it in the Setup|Postprocess tab
because you did not set the bottom height to be the bottom of the pockets you selected (the selected contours in this case). 2D cutting strategies...