Separate names with a comma.
Some features disabled for guests. Register Today.
worked for me on both versions but what it did do is choose the wrong network. I have a virtual network adapter (tailscale) and it chose that as...
earthing is the thing to check I think. high voltage has it's own earth low voltage (24v stuff) has its own earth do not connect the two....
yes
at a thoroughly geeky technical level it is possible to calibrate an unknown system. don't know pitch? don't know microsteps? don't know...
$32 does not enable the laser, it enables 'laser mode'. in laser mode special things are done with the PWM signal during acceleration and...
after crashing a lot I can advise NOT using MDI instead of jog movements (-:
Peter that list in the docs is missing the spindle direction light (6 listed, 7 lights) and that image is not exactly readable, needs about 20%...
our fusion post will handle coolant codes for you without modification.
wow. so, go and grab the master.zip from GitHub - OpenBuilds/OpenBuilds-Fusion360-Postprocessor: Post Processor for Fusion 360 for use with...
so Z lost steps when it raised up, at some point. this can happen when it rapids up, and the solution is a simple 2 parter: in the GRBL settings:...
I think I have a solution up my sleeve, will work on it over the weekend.
if you jog 6 inches does it jog 6 inches?
Homing does it all for you! The setXzero/SetYzero etc buttons set offsets from home, which the controller remembers. When you turn the controller...
it is not hard to allow XZ and YZ arcs in the post, but the big question is how big are the arcs. They were turned off because Fusion likes to...
hmmm, in wood, stepover does not need to be smaller than 5 to 10 steps that the machine can actually do. for most leadscrew machines this means...
I would check all the mechanics first, on a long carve it is likely that chips get into the wheels/V slots, or even into the leadscrews. Any...
first, turn off Capslock, ALL CAPS is shouting on the internet <-:
what software?
hehe, Peter, you never tell people where those files to cleanup are, so for reference, they are in...
set the GRL setting 'step idle delay' to 255 [03:42:36] [ $$ ] $1=255 ;Step idle delay, milliseconds this prevents the motor drivers ever going...