Separate names with a comma.
Some features disabled for guests. Register Today.
1.1h is the last GRBL version, and I see no indications it is running grblHAL even though the board has an ESP32 processor also not seeing the...
perhaps if you post more information about what you do have , specifications and photos, then someone will recongize it and help you.
I believe you flash the 3 axis firmware and then change some settings to prevent it trying to home Z ah yes, BlackBox X32 and Additional or...
peter, do you have a list of the options to pick for a stock X32 build? I'd like to document it as a resource....
lets keep this simple, the BBx32 will run your machine, but because it cannot supply 7amps (and since your drivers are much bigger I would expect...
that could be play in the spindle bearings, when you probe the Z height the spindle has to push hard enough on the probe block to make electrical...
they do work correctly, but everything else has to be done right first. they would help but some elementary thinking on your part can prevent the...
now GitHub - OpenBuilds/OpenBuilds-Fusion360-Postprocessor: Post Processor for Fusion 360 for use with OpenBuilds Machines running Grbl 1.1 file...
the new one that I sent to Mark for alpha testing does...... guess we just need to let it out into the wild....
I would buy an ESP32 devkit board, program it, and wire it directly to the existing drivers and keep both those drivers and the existing power...
soft limtis will give you fits, turn it off (-: always home after power cycle or reset. you can check the offsets by issuing a $# at the serial...
this points to too high max speed/acceleration on Z. on the short moves it does not get going fast enough to fail. fundamentally stepper motors...
You are clearly confused by all the Gcodes that you don't fully understand yet so lets just stick to clicking buttons (-: 1 - turn on machine 2 -...
I would burn aligment holes in the corners and stick dowels throguh the holes to align for gluiing
take the K for example. the kink in the vertical edge on the left is where the Gcode starts and ends, it approaches from the left, starts, goes...
please attach your Gcode
anything above retractheight will be rapid, this means that small positioning moves at the bottom of pockets and slots will still be slow, very...
Are you using the Openbuilds postprocessor for Fusion360? docs:software:fusion360 [OpenBuilds Documentation] (edit: just realized I said Z when...
and check the tram too
you will be happier with changing the Z so the channle stays still and only the plate holding the router moves, like the Sphinx. I have the...