Separate names with a comma.
Some features disabled for guests. Register Today.
those come from the machine setup, what are your GRBL settings for max travel? settings $130 to $132 mine look like this on this test controller...
did the gcode have any G53 moves? previewers typically do not know how to handle those
in what software? in OpenBuildsCONTROL you can select the WCS using the dropdown arrowed below, and of course the GRBL firmware in the Blackbox...
it is time to contact the store Support Remember these forums are for casual member to member community help. if you have an actual product...
2 pin power plug on the laptop? turn it over, sometimes helps
then you have recourse to the store support system Support remember these forums are free support from community members to community members....
ah so, plasma. (tell us the whole story in the fist place and it makes life much easier) the OpenBuilds Fusion360 postprocssor does support...
Typing in commands will cause regular crashes, much better to use jog buttons and jog slowly (if continuous) or jog in known increments If you are...
do NOT use G92 yes it creates offsets (sets your displays to 0), that may be useful in some cases, but it creates GLOBAL offsets that mess up...
with the BlackBox you have, the 4X model, you will only be able to probe X and Y via Fusion360, not a ball/hole/boss. but if you probe the edge of...
I have made some progress adding probing to the post processor for the 4X Blackbox. It will only be able to probe X and Y faces since we have no...
it is in whatever mode tha tlst Gcode set it to. G90/G91 are part of a modal group, things that once set, stay set until changed. Gcode generated...
neither. machine home is set when the controller turns on (can be useful, see later) and then again when the home cycle is run (best) and it...
I understand that when you connect the magnet from the probe (which has 5v DC on it) to the spindle, the Blackbox then says 'probe connected' and...
no, CONTROL will not talk to Marlin. You will be much better off with a Blackbox, much better drivers, standard GRBL firmware, OpenBuildSCONTROL,...
you set up the machines GRBL settings maxrate numbers to rates that the machine can safely handle. After that Gcodes G0 moves are at that maxrate,...
I would flash grbl from openbuildsCONTROL (select blackbox 4x), easiest to do, and will work fine provided you follow the wiring for GRBL1.1
yeah, CAM is available at all levels, but some CAM is not available. free/student does not do 4th axis free does not output rapid moves (maybe...
that is a 4x for that probing will have to be built into the CONTROL software, only a limited amount of probing can be done via Gcode. can do:...
some things are easier than others. Fusion360 is very powerful but is also more complicated. how about just flat 2D drawings? easy, right?...