Separate names with a comma.
Some features disabled for guests. Register Today.
it does use the probe routine, 42 times in fact. lets look at what the gcode is doing G0 X52.679 Y97.318 Z15.24 ; go to initial position,...
this is (or was) common with GRBL controllers, they are little too sensitive to arc endpoint errors. and that tells me we have a solution for...
X axis has backlash, something is loose somewhere so when it drive left then right, or right then left, it does not end up in exactly the same place
maybe you are not proboing far enough and when it hits a low spot it gets tot he end of the probe command before it hits the switch?
use OpenBuildSCONTROL to install the standard XYZ firmware. that gives you Y1 and Y2 both driving Y motors, one driver per motor. then connect Z...
ah yes, settings $30 and $31 default to 1000 and 0. This means M3 S1000 would do full output (5v on your controller) M3 S500 would do 2.5v (or...
software cannot transform 5v into 10v, hardware has to do that, which is what the Blackbox has. the VFD may have a setting that allows it to work...
slow down your Z axis maxrate and acceleration $112=2500.000 ; Z-axis maximum rate, mm/min $122=150.000 ; Z-axis acceleration, mm/sec^2...
much better than my home setup, I have to ftp gcode to the controller (-:
I just tried it add text to blank drawing in OpenBuildsCAM select the text add toolpath to text button 'generate gcode' button 'save gcode' the...
if it is not in the GRBL wiki then it does not exist it is just one button to click on in any decent GUI like OpenBuildsCONTROL, a normal part of...
yes, applies to all of the things because they all use nano scale silicon chip features. printing the circuit board itself with the conductive...
it will never be possible to 3D print effective integrated electronics. the transistors inside a chip are measrued in nanoMeters. a nanometer is...
supported GRBL gocdes are listed here Grbl v1.1 Commands GRBL error codes are listed here Grbl v1.1 Interface
all the things in ( brackets ) are comments in Gcode, they have no effect in the controller only the G64 is a problem for GRBL G40 is accepted but...
GRBL does not support the G64 word, tell the post processor to exclude that from the Gcode output. did CAMBAM do an update?
yes
@Mark R the firmware cannot read usb sticks with 4096 byte sectors reformat them as 512 byte sectors
in that file there are 18000+ lines of average length 0.27", though many of them are much smaller. the circle is also not particularly accurate,...
4096 sectors? maybe the interface is expecting 512 byte sectors?