Separate names with a comma.
Some features disabled for guests. Register Today.
how about enough cable to let the head go around 1 full turn and then in the postprocssor (that makes the gcode) you prevent it going past 1 turn...
Fusion360 is great, and there ar emany videos on Youtube that will teach you how to use the CAM, start with 'Fusion Fridays' from NYCCNC. Yes,...
jog X+ must move the tool right jog Y+ must move the tool away jog Z+ must move the tool up got those correct before setting up homing directions
When I run your Gcode through my controller I do not get an error, there is nothing wrong with the Gcode. So, There must be something wrong with...
then switch to a real USB cable and test. the bluetooth is probably the problem|!!!!!!!!
These are GRBL controllers, they run the GRBL firmware (software in the chip inside the controller) which translates Gcode into motor movement....
I agree. my test Uno next to me is the only one of 4 clones that actually works reliably with GRBL. CH340 usb chip. the other 3 work fine for...
it is time to swap out the USB cable for a shorter, good quality one. that looks like USB corruption, because my previous check showed no...
how much power has been passing through the relay contacts? if you have been switching your router on and off with the relay then you may have...
it depends on what controller you have. if blackbox X32 then change setting $17 grblHAL/doc/markdown/settings.md at master · terjeio/grblHAL if...
hmmm. It should be moving far enough down to press the nozzle against the metal and compressing the spring until the switch is pressed. Then it...
and sorry, did not get to look at the post last night, had to go and tow my daughter home, followed by a loadshedding power out so I went to sleep...
search these forums for 'door input as emergency stop' posts.. been discussed many times
I just looked at the Ortur website and nowhere do they say what controller it is using. I did see some very custom things like flame sensors...
are you exporting the pdf from freecad?? CONTROL cannot read that. (or did you just create the pdf so you can upload it here?) Gcode is a plain...
I think I know the problem. You have connected the switch on Z that senses the contact to the *Z-limit switch input*. It must be connected to the...
come to think of it, that is a very long staydown setting and that might be causing the lack of retracts between probes/cut starts. since it is...
well, how big is the drawing? how big is the machine? the machine has to be bigger than the drawing otherwise it will never work! but as Peter...
your machine thinks it has python 2.7 which is way out of date. upgrade to python 3.9 and then search these forums, someone posted recently about...
which means your gcode part size is bigger than the machine thinks of itself. have you set the sizes correctly? $130 X-axis maximum travel,...