Separate names with a comma.
Some features disabled for guests. Register Today.
what you need is a Lead1515 kit, build it, and actually use it to produce some parts. if it proves to be too small, then order the parts you need...
yes, install the latest firmware from the Wizards and tools|firmware flashing menu in OpenBuildsCONTROL
The Blackbox runs GRBL firmware which uses a serial interface (defined in the wiki) to accept commands. The blackbox accepts Gcode via the usb...
maybe you can make one? https://www.instructables.com/Relay-Controlled-Power-Strip/ google is failing to find any kind of relay power strip...
great, but right now the post supports A axis (-:
I would look at a standard LEAD1515 kit part list but remove the Z axis components, contact the store for help with this. Now you have an XY...
I have the Autodesk generic 4th axis machine selected, both in the Setup and in the NC program and gcode is generated ok. Note that the X32...
there must be many DIY systems on the web for the controller diy telescope control stepper - Google Search for the mechanics I would use belt...
gcode is ok, probably the USB chip.... possibly the USB cable, use a good, shorter one.
please upload the gcode
to be absolutely clear, Z switch must always be at the top of travel, Z+ direction X and Y can be either end, but prefer X+ and Y+ ends
it might, but using a different tap may be better, like a form tap instead of spiral flute, or if you have through holes use a gun tap to push the...
The X32 runs grblHAL firmware which can make use of the following 9 MCS systems - Coordinate System Modes: G54, G55, G56, G57, G58, G59, G59.1,...
you use the GRBL Settings tab in OpenBuildSCONTROL to change GRBL settings. Don't forget to save the setttings, the button arrowed at left will...
I would just import the image into Sketchup and draw around it, that pixelation is going to defeat any automated conversion to vector format.
I would paint it with a primer after the first cut, let it dry, then cut it again with a smaller stepover, say 75% of the first cut. DO NOT...
you put in the stock dimension because we always probe front left corner and then set the offset from there using the stock dimensions. if you are...
check under advanced (top arrow in image below) for which corner you selected the bottom arrow points at the place where you set custom probe...
The voltage is constant on the stepper motors. The current is adjusted with the adjusters on the side of the X32. Read this...
well, yeah, you didn't read the GRBL wiki (-: GRBL does not understand the %ENDMILL... variable definitions, you cannot use this code on a...