Separate names with a comma.
Some features disabled for guests. Register Today.
was it running at a low speed? they tend to overheat if they run at the lowest speed setting for long periods, since there is not enough airflow.
since you have a CNC router why don't you just make a bigger shoe to do what you need? plenty of pictures online to get ideas from (-: as to...
turns out there is a product for that (-: (apart from tensioning the leadscrews) WHIPGONE – Eliminate your Lead-Screw whip problem on Work Bee CNC
do the motors lock up when power is applied? if so then drivers are enabled ok if not then I see you do not have the driver enable wired to the...
have you confirmed that the values of $100 to $102 have changed after the probe? you can do a settings backup in CONTROL before and after to...
connect X motor to the Z socket and see if that moves ok if it does, then Z motor /wiring is a problem if not, then contact the store for proper...
the link i found for the machine says it has nema34 motors which are bigger than nema23 = more power. that is why I suggest the high torque motors...
I think you want to swap in the high torque motors which will work nicely
why do you think a standard openbuilds bracket will not work? Hardware - Components - Page 1 - OpenBuilds Part Store
you are putting the collet into the nut (must click into the retainer ring) before putting the bit into the collet, right?
simple, you are trying to go too fast slow down the max rate settings till it works reliably
I like to scribble all over the outside of the collet with an ordinary pencil (especially with those funky custom collets on cheap routers)....
This explains how to set your origin for the WCS [MEDIA]
and you have watched these... right? [MEDIA] [MEDIA]
I take it you mean in Fusion360? The OB post already inserts a bunch of info about the job, but not as 'variables' because GRBL does not...
so you have 2 pins on the centerline of the material, in the X axis ------------------ Y+ | 0 0 | ------------------ Y- then...
2 sided work is most easily done by incorporating 2 holes on the centerline, can be in either X or Y, I find Y easiest. these 2 holes are in the...
I have published a new version of the postprocessor, get it from github then watch this video [MEDIA]
rule of thumb for electronics: never use more than 80% of the numbers on the label. so the VFD is too small to run 4kw. a 4.5KW vfd would be much...
there are so many reasons why that can be...... from the drawing itself to the setup and the operations in it, everything matters. I have...