Separate names with a comma.
Some features disabled for guests. Register Today.
[MEDIA]
DO NOT push the carriages around by hand unless you have disconnected the motors from the drivers (with power off). cyclic stiffness may be due...
just wire it to ground and signal. you should see it connect in the troubleshooter when you touch the body with the magnet. if it stays...
what you need is an Interface, that will allow both direct control and wifi control of your machine INTERFACE CNC Touch
fixed it, so jump over to GitHub - OpenBuilds/OpenBuilds-Fusion360-Postprocessor: Post Processor for Fusion 360 for use with OpenBuilds Machines...
clearly a problem there, the holes are not drilled, I will debug over the weekend but this is confusing because this is not using a center drill...
I would just replace the control board with almost 'anything else' (-: Why suffer with proprietry stuff when a BTT SKR 3 board (or similar) is...
do not plug in the Interface AND the USB from the PC at the same time. one or the other, since the Interface is desgiend and intended to replace...
There is the problem. That post is written by people who have never actually run a GRBL based machine, so is theoretically correct but in...
aha, didn't think of that (-:
just run a bare copper wire from the tip of the hose, through the seperator, to the vacuum, and ground it there, INSIDE the vacuum pipes. it is...
create for yourself a small gcode file that does nothing and load that when you want to be safe G17 G21 G90 M5 M30
did you actually get the leadscrews and nutblocks from openbuilds store? there are other suppliers that don't always have the same high standards (-:
why? it does not hold the file open so if other software (CAM) needs to rewrite the file, it can do so at any time.
sounds like backlash to me. to remove backlash from the calibration.... lets just to X for now.... jog to the left, say 2" short of the end....
lets fix the axis directions.... unplug the interface from everything plug the usb cable between the computer and the Blackbox open...
yes, we call it an emergency stop and it is a switch that must cut power to the laser and motor PSU. on my machine I use a 'missile switch' (-:...
you still have a lot of backlash in your system, you need to rewatch the build video to make sure you are setting the eccentrics correctly. when...
I think you can just not home A, home will be where it turned on. so after you establish a home position you only need to send it to G53 G0 A0...
your setup origin for BOTH sides must be one of those pins. on side 1 set at the top of the stock in the middle of the pin. on side 2 set it at...