Separate names with a comma.
Some features disabled for guests. Register Today.
when using the OpenBuilds postprocessor you can set the ending X and Y machine offsets to put your tool whereever you want it. DO make sure the Z...
sicne you did not post the full gcode that was not working, nor the project file from fusion, it is hard to diagnose in more depth. I can say...
it has to be, errror 33 only applies to arc and probe commands. please reset your $11 and $12 to the defaults, the defaults work and there is no...
replace your USB cable with a better quality, shorter one. follow ALL of the EMI recommendations in the docs, not just some of them. if you are...
you need a Blackbox X32 in CONTROL you use the wizard to flash the XYZA firmware. exit CONTROL reset the BB start CONTROL and it will show the A...
check matthias Wandel on youtue, he has made a bunch of vacuum systems which may do what you need
the stock GRBL post uses G28 which requires a bunch of knowl;edge to work correctly the openbuilds GRBL post uses G53, which only requires homing...
when control asks the Blackbox who it is, the BB is telling it that it has an A axis. so, either it is lying, ie a USB communication error, turn...
well, it is stuck hard on something, you rmission is to find out what and remove it (-:
clean the machine so you can see what is making it stick. debris under the wheels can easily cause sticking like that. with power off, can you...
ok, but with GRBL in laser mode then M4 will ramp the PWM as the motion speed ramps, not what you want for plasma (-: look sliek anice machine...
I have tried this on a bare Uno and now again on a BlackBox 4X with GRBL 1.1f loaded via OpenBuildsCONTROL (and just tried it with the X32 with...
you must power cycle the Teensy after changing that parameter
maybe you flashed the ACRO XY only firmware?
what 2022 Darwin should have done is create metadata, data about the data (-: I use README files, put the gcode into a folder and a README file...
yes there is such a setting, and the default for OpenBuilds profiles loaded to a Blackbox is 'always on' , I wonder what changed it? (might...
no, Gcode is relative to the WCS origin that you set in the 'setup' in Fusion. WCS = Workpiece Coordinate System The WCS is relative to the MCS...
what have you drawn in fusion? a sketch rectangle the size of your spoilboard? that is probably bigger than your actual limits, so if you just...
cyclic stiffness is an off center pulley not the bearings, they will outlive us all unless you pour sand in them
there is an M code for it, read all about it here M-Codes but you will need something other than CONTROL, I recommend bCNC GitHub -...