Separate names with a comma.
Some features disabled for guests. Register Today.
arduino based GRBL resets on connect, grblHAL 'might' reset on connect.
size: vectric must have options for increasing the smallest linelength that it will try to cut, use that to reduce file size. This will be...
[MEDIA]
you are trying to use the X32 multiaxis post which is milling only, says so right in that message. Use the file OpenbuildsFusion360PostGrbl.cps...
you must upgrade your postprocessor to match the new version of Fusion docs:software:fusion360 [OpenBuilds Documentation]
(note: ChatGPT does an excellent job of translating between languages) looking at your Gcode I can see that i was correct, your curves have many...
Please upload your Gcode file so we can have a look but my first guess is that the curves have a LOT of very small line segments, looks nice on...
with a micrometer you hold the tool between the faces and gently rotate it as you widen the jaws slowly, when it just slips free, that is the...
no, GRBL does not support a table of tool offsets, therefore CONTROL does not do so. it also does not support tool changes. but there are...
the acceleration and speeds you set for the controller are used for: accleration is used for all moves, both when starting and when stopping max...
being new you should read the GRBL wiki, yep, all of it. it will give you background info so you know where to look for any furture things to...
turn laser mode off in the GRBL settings grbl/doc/markdown/laser_mode.md at master · gnea/grbl
your enemy will be whip during rapid moves, but if you are happy to limit the maxrate to keep it happy, then it will be fine. you can also make/3d...
set the axis( jog) direction so Z+ moves it up then try a home and if it goes down instead set the 'home insvert mask' to Z goes up for the homing
look for a local model train club, one of them can just turn them shorter on his lathe (-:
because the switches have 3 terminals and you used the wrong 2 (-: typically there is a 'common' terminal and a Normally Closed (opens when...
used chatgpt to translate, you can too "When I want to export the file from Illustrator to CAM, vectorized, it exports incompletely, even though...
and check that in mounting the switches you did not mount them upsidedown and cause a short between the circuit and the frame
yes, you need to adjust the acceleration values for all 3 axes. the defaults (you did load a machine profile, right?) are usually quite slow but...
also, if it was working, there is no need to reflash the controller.