Welcome to Our Community

Some features disabled for guests. Register Today.

laser add-on for C-Beam machine

Discussion in 'Laser Cutters' started by Jurgen, Jun 25, 2016.

  1. Jurgen

    Jurgen New
    Builder

    Joined:
    Dec 11, 2015
    Messages:
    13
    Likes Received:
    23
    Jurgen published a new build:

    Read more about this build...
     
    MaryD and David the swarfer like this.
  2. Kyo

    Kyo Veteran
    Staff Member Builder Resident Builder

    Joined:
    Feb 27, 2014
    Messages:
    673
    Likes Received:
    702
    That is awesome, I like how you designed it to be swapable with a router. Any pics of items engraved or cut?
     
  3. Jurgen

    Jurgen New
    Builder

    Joined:
    Dec 11, 2015
    Messages:
    13
    Likes Received:
    23
    Sorry, but no not yet.

    I am currently searching for some plywood or so to start some cutting / engraving
    I also need a different workpiece carrier - something like a "blade table" or just some Aluminum foil.
    ....but this might be to reflective and the Laser will be all over in the room.
    Enclosing the machine with "LASER shield" seems to be the way!

    I only focused the laser so far and I only managed to burn a spot into my dining table ;-)
    (The Laser was about 15cm away from the surface and switched on for about 2 seconds - focused somewhere)

    JTech has some good cutting and engraving docu you can check.
    It might be a while until I get these results ;-)
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice