Cube 3 / Pro hacks

i´m sorry buit i still dont get how it works.

I download the cubetool box, but how do i get the firmware to patch it ?

 

I would suggest being very careful with the CubePro. Several complaints have been lodged saying the chamber heater fails after the patch. Considering you have to interrupt the installation process, this is a problem that only shows up for some. I've settled for the chip recharging solutions for CubePro. This is not the case for Cube3. The installation is cleaner.

 

Hello, I have a CubePro that I purchased in 2015. It has worked fine for all this time. However, my last print failed miserably and since then the printer’s jet carrier will get to a location near the left rear and seize and buzz/squeal until the power is turned off. It is easy to reproduce by simply pressing the Change Cartridge on the main menu. The carrier will move to the same point and just buzz…. However, I can manually move the jets all around without any issue. I can test the jet and the filament flows just fine.
Does anyone have any idea what the problem is and how I would go about fixing it. Sorry if this post is hijacking the thread? Point me to another forum and I will happily post my question there. Thank you for any assistance!!!!