Welcome to Our Community

Some features disabled for guests. Register Today.

Cutting depth issue

Discussion in 'OpenBuilds Forum Help' started by JON D, Mar 11, 2021.

  1. JON D

    JON D New
    Builder

    Joined:
    Apr 15, 2014
    Messages:
    16
    Likes Received:
    2
    So I have finally completed assembly of my machine. I built it excatly like the original model part for part. I am using a x controller and easel to run everything. I have tried manually setting the zero on the material and also tried using a z probe. When I use the z probe it runs the bit through the work piece and spoil board. When I use the manual method it doesn't go as deep and I can run out a project but its deeper then the spec I set for cutting depth. Any help or thoughts would be greatly appreciated.
     
  2. OICITNOW

    OICITNOW New
    Builder

    Joined:
    Jan 19, 2021
    Messages:
    25
    Likes Received:
    19
    Just a thought...Did you calibrate it?
     
    sharmstr likes this.
  3. JON D

    JON D New
    Builder

    Joined:
    Apr 15, 2014
    Messages:
    16
    Likes Received:
    2
    Not excatly sure what part or how to calibrate it.
     
  4. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,059
    Likes Received:
    1,448
  5. JON D

    JON D New
    Builder

    Joined:
    Apr 15, 2014
    Messages:
    16
    Likes Received:
    2
    I'm new to this end of cnc stuff so is there a link to the calibration software and possibly like a step by step guide?

    Also do you know if there is a way to do it through easel or with the x-controller?
     
  6. sharmstr

    sharmstr OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 23, 2018
    Messages:
    2,059
    Likes Received:
    1,448
    Sorry, missed the part where you said you were using the xcontroller. Anyhow, lots of info on their site

    Calibrate z axis (How to?)

    and


     
  7. JON D

    JON D New
    Builder

    Joined:
    Apr 15, 2014
    Messages:
    16
    Likes Received:
    2

    I got it calibrated today following the link and videos you sent. Seems to be working great now. Thank you very much for your help
     
    Peter Van Der Walt and sharmstr like this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice