Separate names with a comma.
Some features disabled for guests. Register Today.
VFD/Spindle would be an EMI source when absolutely all power is cut off going to it? Cause as I said, this happens even in that situation. Also,...
Hello, So, while searching I've seen a couple of other posts about this, but never with any conclusion. So, I wanted to check and see if anyone...
Hello all, I'm no expert when it comes to this stuff, I know enough to have built a couple of laser cutters safely. But, I'm in a situation atm...
So, I've had my blackbox for a couple of weeks now and it's been working great. But I had a question about the fan, is it supposed to be running...
So yeah, think I got these issues resolved now. My E-Stop and Main power switch are now both chained together to energize the coil on a 120v coil...
I have tried rebooting the laptop and the problem cropped up again (I'm a software developer, so I've thought to do some basic troubleshooting...
Right now I'm running it off my laptop which is a fairly recent and descently powerful laptop... It has an 8th gen Core i7 processor that turbos...
Hello all, I finally finished my CNC build today after getting the openbuilds blackbox in the mail. I've ran into 2 problems so far that I'm not...
Hello everyone, I'm building a new laser cutter and looking at getting one of these tubes for it: 80W CO2 Laser Tube for Laser Engraving Cutting...
Yeah lol, thinking about it a little further you wouldn't be able to get quite 18" without doing rails because of the spacing of the wheels on the...