David the swarfer's Recent Activity
-
David the swarfer liked Peter Van Der Walt's post in the thread X axis getting stuck.
1) During the crash something may have become moved, bent or damaged: Perform a check on all the mechanicals making sure its all...
Oct 15, 2024 at 3:03 AM -
David the swarfer liked Peter Van Der Walt's post in the thread Blackbox x32 trying to run inventables easel.
Use easel to generate gcode: https://inventables.zendesk.com/hc/en-us/articles/4406926040979-Exporting-Gcode-From-Easel Then run it as...
Oct 14, 2024 at 2:31 AM -
David the swarfer replied to the thread X axis getting stuck.
that leadscrew is much too tight, check the nut adjustments, and alignment etc. also the bearings on the ends of course. remember to...
Oct 14, 2024 at 2:31 AM -
David the swarfer replied to the thread X axis getting stuck.
my X had some sticky spots (a screw head was hitting the rail, sometimes) and I had to do a combination of slowing down the axis (both...
Oct 13, 2024 at 12:35 PM -
David the swarfer replied to the thread x32 z limit switch stays triggered.
pity, could be as simple as inverting the sense of the switch, the box caters for both normally closed and normally open switches, but...
Oct 13, 2024 at 12:32 PM -
David the swarfer liked Mark Carew's post in the thread Prayers..
We made it! It was a crazy storm for sure and we thank you all for the prayers! There is so much widespread damage it's crazy! I have...
Oct 11, 2024 at 3:00 AM
-
David the swarfer liked Peter Van Der Walt's post in the thread BlackBox x32 Trigger signal.
I'd recommend handling that in your host software. Move 10mm, do what you need to do. Move next 10mm. Send commands when needed, watch...
Oct 10, 2024 at 3:41 AM