Separate names with a comma.
Some features disabled for guests. Register Today.
Something to consider is shorten the ballscrew length. One of the issues with the HDZ is that by the time that the screw is bound (threaded all...
Tramming is the process of making sure that your spindle is square and straight up and down. Normally it is done using very thin shims.
Nice Fusion Models :)
Thanks for that Savvas that looks fantastic. They are not that common in the USA but it think i can get a couple.
Great build. You would not happen to have a link to the adapters that you used for the water tubes per chance would you. I have the same spindle...
Hi Kyo great build. One thought with the BOM is it worth while for a couple of the parts to list what would be needed as additional purchase vs...
Great build. Are you controlling the spindle from Tiny G or doing manually? If you are doing it from the TinyG are you doing all 3 options (On,...
@shugster yes those are the servo's. Required a different power supply and some extra control wiring but they reduce the noise by about 100%....
The steppers are noisy. I was planning on swapping my x and y before the accident. After it was a must do as lugs were broken on the steppers so i...
Well i hope that this next weekend when i get back home i can finally get my plate maker working again. It was working and then it had a close...
Looking very smart there @motopreserve with the red stripes
Looks good there @Tyler Harney
@Jonatan Rullman One benefit most likely of the water cooled spindle is that you should be able to control the spindle speed in software rather...
Charliex, Motopreserve there is a new firmware ending in 18 for the tinyg that fixes the you have to reboot the tinyg each time you make a...
Motopreserve look at fusion 360 as it also has the cam and cad side.
