Separate names with a comma.
Some features disabled for guests. Register Today.
I've definitely seen another off-the-shelf with that ability to heat only a center section of the bed. No idea how well it works. I'd say you'd be...
That's fine. im aware there are lots of lurkers reading so feel like I should drop into any talk about mains to warn that It's not fault tolerant...
That bed is 12V, 220W. You definitely want to go bigger on both wattage and voltage. I'd avoid mains unless you're really comfortable with mains...
I'd say that a 3mm heatspreader is probably a bit thin for such a large print size (assuming you're going to be using it all). As this will be the...
Sounds good, but the real test will be with a feeler guage and when your toolhead is installed. Your laptop is most likely more than 1kg in...
Is this the first 300x300 bed on a cantilever Z stage? I'd be really interested to see how you get on with how rigid the set-up is
Cheers Carl. I generated it using my pinion gear generator Gear generator for Solidworks (Straight / Helix / Herringbone) by austingeorge I've...
For the amount of times you'll adjust the belt tension, the clamps currently used are fine IMO. An adjustable one would be significantly more...
I bought a wanhao i3 last year and sold it a few months ago for £30 less than i paid for it. Definitely the cheapest way to print parts if you...
That doesn't look like ringing from accel/decel, but i could be mistaken. Can't help but think it might be an issue with your rails or motion...
It's in my post above. I don't use carls models directly, as i re-did them in solidworks, but used the same idea, whereby if a wheel is fixed by a...
Just wanted to re-visit the steel and fibre belt info me and @CapnBry were talking about a few pages back. My black fibre belts came in last...
This is the C-Bot build forum. No relation to the Tevo afaik? Carls models have a drafted fixing surface for the bolts that hold the wheels in...
Not that difficult if you have an extra bar of 1500mm extrusion, a spare stepper, belt, and pulley. Remember typical phone GPS accuracy is never...
I use Slic3r as a slicer, and repetier host as a print controller. Slic3rs views really come in handy when you're fiddling and testing new...
