Hello and thanks again for your previous help. My worckbee works but I hava a litle problem. the projects carve in miror like there was a 180 degre rotation on the axe "x". How resolve this problem pls? Alex
Rotation or Mirror? (Title says one, post says another) Mirrored is simpler (Grbl Settings tab > $3 Direction Invert > Flip switch for offending axis Rotation could be both X and Y need Direction Invert,( or you wired X to Y)
Test by jogging. Jog X+ > did toolhead move right? If not. Correct $3 in Grbl Settings Same for Y etc
It's not that, when I jog + the axes go to + and the right Is it possible that it is due to the direction of extrusion when I create my part with solidworks?
Because it hasn't been set up correctly?? Does the spindle move away from the front of the machine when you jog Y+? If not, the Y axis is reversed. Corrected by setting the direction invert mask in the GRBL settings ($3 as Peter posted above) - Go to the 'Grbl Settings' tab in Control and the settings for each axis are there alongside the $3 key. Restart Grbl after making any changes, just to be sure.
Then refer earlier advice: Flip the offending axis (looks like its flipped on Y) So, what about jogging Y? Does Y+ move the Toolhead to the Rear of the stock? (If not, invert)
jog X+ must move the tool right relative to the work jog Y+ must move tool away relative to the work jog Z+ must move tool up away from work yes, it is possibly you did something 'interesting' in solidworks, check the setup origin