Well i have blackbox x4 and i'm using artcam 2018 and carveco but when i save my projects the open build software font open my g-code Error "the gcode file u loaded contains g53 commands Pls make sure to home the machine to establish the machine coordonates g53 My machine runs g54 as i know I'm newbie so please be patient Thabks
Please upload your g-code file. G53 is the machine co-ordinate system, G54 is the first of the workplace co-ordinate systems We need to ssee what those G53 commands are. Alex.
Its not an error. Its a reminder to HOME! You haven't yet, and there are some Z safe moves or similar in G53. Don't overthink it. Just HOME as requested
If you have not homed yet, its warning you its not homed: Check if machine is homed and if any G53 moves are in the GCODE, Ask to Home · Issue #219 · OpenBuilds/OpenBuilds-CONTROL Note the wording of the message: "TIP:..." - its of course up to you to decide whether to ignore the advice, but homing is always a good idea The sample file you uploaded is not one that contains G53 and does not raise the message either - but your other file might have.
no G53 in that file, but it does have a T1M6 toolchange which you will need to remove. some resources for you to learn from: (knowledge is power!) the what and how of G53 Home, Fusion360 and G53 Z moves if your machine does not have home switchesm then you need to fake it How to 'Fake the home'